Maintaining Control Parameter Records; Using The Keypad/Display - Daikin Rebel Applied DPSA Installation And Start-Up Manual

9. Set the control timers as required in keypad menu
Menu\Commission Unit\Timer Settings.
a. Set the date and time in keypad menu
Service\Time/Date\.
b. Set the operating schedule as required using
keypad menus.
and Date/Time/Schedules.
NOTE: When used with a Building Automation System, these
settings may need to be kept at the default of no
schedule:

Maintaining Control Parameter Records

Daikin recommends that the MicroTech 4 controller's setpoints
and parameters be recorded and saved for future reference. If
the Microprocessor Control Board requires replacement, this
record facilitates entering the unit's proper data. The following
tables display all the setpoints, monitoring points, and program
variables offered by MicroTech 4 plus the keypad road map
used to find each parameter.
A number of menus and menu items that appear on the unit
keypad/display are conditional and may not apply to a specific
unit, depending on the unit software configuration. The unit
software configuration is defined by a "Software Configuration
Code" shown on a label located near the keypad/display. The
Software Configuration Code also can be displayed via the
six menu items in the Config Code menu on the unit keypad/
display.
NOTE: Keep a record of any changes made to any of these
items.
Figure 50: Keypad Controls
www.DaikinApplied.com
Setup/
Main Menu\ViewStatus\Date/ Time
System Summary
Advanced Menus
Alarm Lists
Unit State= Cooling
Clg Capacity=

Using the Keypad/Display

Main
The keypad/display consists of a 5-line by 22 character display,
three keys and a "push and roll" navigation wheel. There is an
Alarm Button, Menu (Home) Button, and a Back Button. The
wheel is used to navigate between lines on a screen (page)
and to increase and decrease changeable values when editing.
Pushing the wheel acts as an Enter Button.
The first line on each page includes the page title and the line
number to which the cursor is currently "pointing". The line
numbers are X/Y to indicate line number X of a total of Y lines
for that page. The left most position of the title line includes an
"up" arrow to indicate there are pages "above" the currently
displayed items, a "down" arrow to indicate there are pages
"below" the currently displayed items or an "up/down" arrow
to indicate there are pages "above and below" the currently
displayed page.
Each line on a page can contain status only information or
include changeable data fields. When a line contains status
only information and the cursor is on that line all but the value
field of that line is highlighted meaning the text is white with
a black box around it. When the line contains a changeable
value and the cursor is at that line, the entire line is highlighted.
Each line on a page may also be defined as a "jump" line,
meaning pushing the navigation wheel will cause a "jump" to
a new page. An arrow is displayed to the far right of the line to
indicate it is a "jump" line and the entire line is highlighted when
the cursor is on that line.
The keypad/display Information is organized into five main
menus or menus groups; Alarm Lists Menu, System Summary
Menu, Standard Menus, Extended Menus and Advance
Menus.
NOTE: Only menus and items that are applicable to the
specific unit configuration are displayed.
3/23
25%
47
Unit Operation
IM 1287 • REBEL APPLIED ROOFTOP