Accessories - Poulan Pro PR28PS Operator's Manual

8. Get a rounded front corner of the depth gauge with
the flat file. Make sure that the top of the depth
gauge is level.
To lubricate the guide bar and the chain
WARNING: Do not use waste oil. To use
waste oil can be dangerous to you and can
cause damage to the product and
enviroment.
The chain oil supplies continuous lubrication to the chain
and the guide bar. The oil output is automatically
monitored to make sure that there is sufficient oil. If
there is no sufficient oil, it will cause damage to the
guide bar and the chain, and too much heat. Too much
heat causes smokes in the chain and/or can change the
color of the guide bar. Always fill the bar oil tank when
you fill the fuel tank.
Obey these instructions to lubricate the guide bar and
the chain:
1. Stop the engine.
2. Remove the oil cap.
3. Fill the bar oil tank.
To do the maintenance on the guide bar
WARNING: Do the maintenance on the
guide bar when:
• The product cuts to one side.
• You must push the product through with
force.
• The lubrication of the guide bar is not
sufficient.
PR28PS
Approved accessories
Thread shaft (5/16 R)
Trimmer head
Optional accessories
Edger attachment with shaft
Cultivator attachment with shaft
Blower attachement with shaft
Brushcutter attachment with shaft
Saw attachment with shaft
226 - 004 - 17.10.2018
1. Disconnect the spark plug.
2. Loosen the clamp nut and remove the chain brake.
3. Remove the guide bar and the chain.
4. Clean the oil holes and the groove.
5. Remove the burrs of the guide bar rails with a flat
6. Use a flat file to restore smooth edges and sides if
7. Replace the guide bar.

ACCESSORIES

Type
P25
After each operation, clean all sawdust from
the guide bar and the sprocket hole.
WARNING: Replace the guide bar when:
• The groove is worn.
• The guide bar bends or has cracks.
• The guide bar rails get too much heat
when you cut.
• Burrs occur to the guide bar rails.
It causes damage to the chain and becomes
not easy when you cut if the guide bar is
worn.
Note: It is necessary to clean the oil holes and the
groove after each 5 hours operation.
file.
Note: Burrs of the guide bar rails are a usual
process when the guide bar rail wears.
the top of the guide bar rail is rough.
Cutting attachment guard
585345904
Type
PP1000E
PP2000D
PP3000B
PP4000C
PP5500P
Use with
PR28PS
PR28PS
PR28PS
PR28PS
PR28PS
19