Ordering Data; Installation - Siemens SIMATIC Ident Compact Operating Instructions

1 Characteristics
Transponder corner bracket
for MDS D160, D460 and D560
2

Ordering data

Table 2-1 Ordering data for transponder corner bracket for MDS D160, D460 and D560
Transponder corner bracket for MDS D160, D460 and D560
(packaging unit 50 units)
3

Installation

Note
Temperature during installation work
The transponders must be mounted and disassembled at room temperature.
Mounting the transponder and the transponder corner bracket
To mount the transponder, follow these steps:
1. Insert the transponder into the transponder corner bracket diagonally from above.
2. Press the transponder down slightly until the transponder is latches in the transponder corner bracket.
3. Fasten the transponder corner bracket with a M4 cylinder head screw.
Note
Additionally securing the fixing screw
If the transponder corner bracket is exposed to frequent temperature fluctuations and mechanical shock, additionally secure
the fixing screw, e. g. with screw retainer finish or lock nuts.
Disassembling the transponder
To disassemble the transponder, follow these steps:
1. Use a suitable tool, e.g. a flat screwdriver, to pry the transponder out of the transponder corner bracket.
2
Characteristics
Area of application
Operating temperature
Material
Color
Dimensions (W x H x D)
The transponder corner bracket can be mounted at an angle
of 45° to the corner of a workpiece holder, so that the MDS
Dx60 transponder attached to it can be equally processed
regardless of the conveying direction (longitudinal or trans-
verse conveyance).
-25°C ... +85°C
PA6-GF
Black
19 x 27.5 x 18 mm
(without alignment pin)
Article number
6GT2690-0AN00
Transponder corner bracket for MDS D160, D460 and D560
C79000-G8976-C492-01, 12/2017