Specifications; Standard Equipment; Pre-Operation Inspection - Greenlee GRE 6 Operation Manual

Specifications

*
With 2 Ah Battery
Figure 6 – Specification Chart
Piston Force ...............60 kN (6-ton) (13,500 lbs.)
QCS Coupling Type ...6T QCS
Duty Cycle..................
Motor
Voltage ...................18V DC
Amperage ...............18 Amp
Power .....................324 Watts
Battery........................18V Li-Ion, Rechargeable Batter y
(see Optional Equipment)
Ingress Protection .......IP32
Allowable Humidity......0-80%
Operating Temperature
Range ...........................15° F to 122° F (-10° C to 50° C)
Storage Temperature
Range ...........................32° F to 113° F (0° C to 45° C)
Sound Pressure (L )* ...65 dB(A), K=3
PA
Sound Power (L )*.......76 dB(A), K=3
WA
Vibration .......................<2.5 m/s
*
* Sound and Vibration measurements are measured in accordance with a stan-
dardized test per Standard EN 62481-1.
- Vibration levels may be used for comparison with other tools and for pre-
liminary assessment of exposure.
- Sound and vibration emissions may vary due to your location and specific use
of these tools.
- Daily exposure levels for sound and vibration need to be evaluated for each
application and appropriate safety measures taken when needed. Evaluation
of exposure levels should consider the time a tool is switched off and not in
use. This may significantly reduce the exposure level over the total working
period.

Standard Equipment

Refer to the Greenlee catalog for details on equipment
supplied with specific tool catalog numbers.
Selection of appropriate materials and joining
NOTI E
methods is the responsibility of the system designer and/or
installer. Before any installation is attempted, careful eval-
uation of the specific service environment requirements
should be completed. Consult connector manufacturer for
selection information.
6
Model Description
GRE 6 6T Tool For Use
w/Interchangeable Heads
* 1
Includes dies
3 Cycles per minute
2 , K=1.5
Weight * Dimensions
L x H x W (mm)
g lbs
L x H x W (inch)
3000 6.6 318 x 154 x 73
12.5 x 6.1 x 2.9
* 2
Versions for Cu/Al wire and ACSR available - See blade markings.

Pre-Operation Inspection

Daily before use, inspect your electrical tool and cor -
rect any problems to reduce the risk of serious in jury
from electric shock, crushing injures, equipment
failure and other causes, and prevent tool damage.
1. Remove battery from tool.
2. Clean any oil, grease or dirt from the tool and head,
including handles and controls. This aids inspection
and helps pre vent the tool or control from slipping
from your grip.
3. Inspect the electrical tool for:
• Proper assembly, maintenance and completeness
(See Figures 1-2).
• Any broken, worn, missing, misaligned or binding
parts.
• Presence and readability of the tool and battery
warning labels.
• Any other condition which may prevent safe and
normal operation.
If equipped with the QCS Coupling, inspect for:
• Foreign material in the QCS coupling (see Main-
tenance section).
• Confirm that all retaining balls are present in all open-
ings and that there is no damage. Figure 7 shows the
inside of a complete and clean QCS coupling.
• When inspecting the mating QCS coupling on inter-
changeable heads, dimples in the grooves of the
QCS coupling are normal with use and are not con-
sidered damage (Figure 8).
Piston Travel Service
Interval
mm inch
Cycles
32 1.3 32,000
WARNING
999-999-200.10_REV. A