Changing The Resolution; Software Suite; Basic Settings; Key Settings - Nacon GM-300 Instruction Booklet

First-time connection with the PC
The NACON GM-300 optical gaming mouse is a so-called Plug´n´Play device. This means that the necessary
driver software should be installed automatically if you connect it to your computer for the fi rst time. Here are the
steps in detail :
• Turn on your computer, wait for it to boot and log in to your Windows desktop.
• Look for an unused USB slot on your PC and plug in the USB cable of your NACON GM-300 optical gaming
mouse.
• Windows will detect the new device and after a few seconds it will start the installation process for the
appropriate drivers. This is shown by a small icon in the taskbar.
• The installation might take a while depending on the speed of your system. Once the installation is complete,
you will see the icon change. You can now use your mouse.

Changing the resolution

The NACON GM-300 uses an optical sensor to track your movements and transmit this information to your
PC. This sensor can operate at various resolutions ranging up to 2500dpi. The higher the resolution, the more
precisely your movements will be tracked, but the harder you might feel it is to point the cursor at a specifi c point
with your mouse. By pressing the DPI +/- buttons located below the mouse wheel you can from up to 4 diff erent
resolutions. For more details refer to the next section.

Software suite

Your NACON GM-300 off ers a lot of functions which can be unlocked by downloading the driver software from
our website www.nacongaming.com. To install the software double-click on the fi le `Nacon GM-300.exe' and
follow the on-screen instructions after the download has completed. After the installation is fi nished the software
creates shortcut icons, on the desktop and in the Windows Start menu, which you can use to start the software.
Hint: For driver updates please regularly visit our homepage www.nacongaming.com. You can do so by simply
clicking on the link at the bottom of the software window.
If the driver is running, you see the NACON snakehead logo in the taskbar. You can bring up the software by
simply clicking on that logo.
On each screen you fi nd three buttons on the lower right side:
•[OK] Lets you save the settings and minimizes the driver again
•[Apply] Saves the settings and transmits it to your mouse without closing the window
•[Cancel] Minimizes the driver without saving the changes
Note: Please note that after clicking APPLY it takes a while for the software to transmit the new settings to the
GM-300. APPLY stays highlighted until the transmissions has fi nished.
By clicking on the mouse and the cog wheel icons in the upper left corner of the window, you can switch between
the basic and the advanced settings pages.

Basic Settings

Key Settings

This menu is used to assign new functions to the buttons of the mouse.
Hint: It is impossible to assign new functions to the left and right mouse button.
EN
n
GM-300