Sony Ericsson T610 Working Instructions page 10

#
30
31
32
33
34
3/000 21-1/FEA 209 544/76 C

SonyEricsson Mobile Communications AB
Figure
fig2.7
fig2.8
fig 2.9
fig 2.10
fig 2.11
Working Instructions, SP/Mechanical
Instruction
Pick up the speaker from the
tape & reel with the flex film
assembly tool and mount the
speaker in the Frame cavity.
( fig.2.7).
Mount the speaker gasket over
the speaker. The gasket shall
not cover the contact pads and
speaker cavity edge at the
arrows.
( fig 2.8)
Mount the system connector
on the PCB with your fingers.
Push it on in the arrow
direction
( fig 2.9)
Mount the sound channel
gasket on the PCB with a pair
of tweezers.
Use the IRDA sidewall (1), the
PCB edge (2) and the PCB cut
(3) to place it in the correct
position.
(fig2.10)
Mount the camera holder over
the shielding can with your
fingers. Snap fit the holder
centred over the shielding can
and make sure that the camera
stop pin (arrow) is correctly
oriented.
( fig 2.11)
Note
The contact pads on the
speaker mus be mounted
upwards.
Do not contaminate the
speaker contact pads.
The system connector will
be straight and parallel to
the bottom line of the PCB.
Wrongly mounted it can
cause damage to the small
components close to the
PCB bottom line.
The camera holder has
normally not been removed
in disassembly.
This is only to be done if
the camera holder has been
removed by accident.
10(33)