Trail; Looper Mode - Mooer GE200 Quick Start Manual

Trial On function allows the trail of delay/reverb effects ton continue for
a few seconds after the delay/reverb effects are turned off.
For example:
1. When using CTRL to turn off the delay/reverb effects, the trail will
continue for a few seconds after it has been turned off.
2. When switching between different presets, the trail will continue for
a few seconds after switching.
LOOPER POSITION
In firmware V2.0, the PRE/POST looper function has been added.
The signal chain is shown below:
INPUT
PRE: The LOOPER will be placed in front of the effects chain in order to
record the dry signal directly from your guitar. In PRE mode, the effects
chain can be fed by the recorded track and you can adjust the effects chain
in real time to get different output tracks.
POST: The LOOPER will be placed at the end of the effects chain in order
to record the wet signal as the output from the GE200. In POST mode, the
looper works as a traditional one does. Once the track is recorded, it
cannot be affected by effects inside from the

TRAIL

LOOPER MODE

PRE
LOOPER
EFFECTS
CHAIN
06
POST
LOOPER
OUTPUT