Equipment Support Bar Design - Saluki ADS2100C User Manual

level should be until the sign is completely solidified (about 12h at room temperature).
When the concrete is poured to 0.2 meters below the ground, the outer wall of the observation pier should be embedded

with a rigid pipe (steel or plastic) with a diameter of 25mm or more suitable for the cable entry and exit for the installation of
cable protection lines.

3.3 Equipment Support Bar Design

Infrastructure and concrete pier are fixed by Q235 carbon steel flange. The size of the flange is φ450×15mm. The flange is

evenly distributed with 8 M20 threaded holes.
The support rod is made of Q235 steel structure, the exterior is painted white, the outside diameter of the rod is φ90mm,

and the thickness is 4mm.
The waterproof box is mainly used to place switches, power adapters and other devices; the waterproof box is fixed to the

support bar mounting plate with 4 M8 screws. The size of the waterproof box should be greater than 300mm×200mm
×140mm.
The flange of the supporting rod is fixed to the flange of the equipment, and the detection equipment and interference

equipment are fixed by four M6 screws.
- End of Document -
8
Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com