Exception Solution - Saluki ADS2100C User Manual

When the signal is on, Ublox-M8T deception positioning diagram is as below.
After the signal is turned on, the number of GPS / GLO positioning stars is significantly increased. After the signal is turned on,
the GPS / GLO is affected by the deceptive signal, and the positioning point follows the device to deceive the signal to move.

2.4 Exception Solution

1) After the system is powered on, it cannot enter the working state.
Check whether the power supply of the device is normal and whether the power cord is tightly connected.

Check whether the surrounding environment meets the requirements for product use.

2) After the system is powered on, the signal output cannot be detected.
Check whether the surrounding environment meets the requirements for product use.

Check if the system startup is complete. It usually takes 6 to 10 minutes for the system to start, and no signal will be output

Figure 2.4 Software screenshot of signal turn off
Figure 2.5 Ublox-M8T deception positioning diagram
6
Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com