Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
Figure 2.2 Install the screws
Install the power cord, as shown in the Figure 2.3, plug the power cord into the power socket on the bottom of the device.
Figure 2.3 Install the power cord
2)
Power on
Plug the power cord into a 220V AC power supply and wait for 6 to 10 minutes before the device automatically goes into
operation.
2.3 Commissioning and Testing Scheme
The ADS2100C device has the characteristics of transmitting GPS and GLONASS satellite navigation deception jamming
signals. After confirming that the equipment is working properly and broadcasting the signal, you can use the mobile phone map
(or other navigation signal detection software) to check whether the navigation signals are affected by the deception jamming
signals and the positioning is biased Shift situation.
The following figures are the screenshot of the U-CENTER 8.29 receiver software. The upper left corner of the software
screenshot represents the satellite asterisk diagram received at the current position, and the middle represents the movement
track diagram of the current positioning point.
When the signal is turned off, Ublox-M8T is positioned to the sky normally.
5