Table of Contents
Advertisement
C-Series AS-i Master Module
Operating the AS-i
Programming the Address in Case of Configuration Errors
1.
Click the button "Store Actual Configuration" to store the current AS-i net-
work configuration for all connected slaves, then repeat step 2 – 5 from
above.
Erasing the Slave Address
1.
Remove a slave from the AS-i network
2.
The status of this slave in "Slave List" indicator should change to P (Pro-
jected Only)
3.
Click the button "Store Actual Configuration" to delete the address from the
module.
Automatic Address Assignment ( shall be processed only if):
1.
the Master module execution control mode is the protected mode,
2.
the "Auto_Address_Enable" mode is ON
3.
the "Auto_Address_Assign" mode is set, and If one and only one configured
slave is not detected.
7.3
Examples of address assignment
7.3.1
Example of automatic address assignment
1.
Select an existing Slave (e.g Slave1) within the "Old Address" control.
2.
Select Slave0 within the "New Address" control.
3.
Click the button "Change Slave Address". The status List should change
like this.
4.
Remove the slave from the AS-i network.
5.
Click button "Operation Mode" to change to protected mode
6.
Connect this slave back to the AS-i network
7.
Address 1 is assigned to this slave automatically.
7.3.2
Example of manual address assignment
1.
Connect a slave to the AS-i network.
2.
If the slave address is zero, the status list should look like this.
Subject to technical modifications; no responsibility is accepted for the accuracy of this information
Internet: www.bihl-wiedemann.de • Flosswoerthstr. 41 • D-68199 Mannheim
© Bihl+Wiedemann GmbH
phone: +49 621 33 996-0 • fax: +49 621 3 39 22 399
19
Advertisement
Table of Contents
