Kenmore 796.3146 Series Use & Care Manual page 29

BEFORE CALLING FOR SERVICE (continued)
Washer will not a_rate
Control panel has powered off due to
inacfivffy.
Washer _sunplugged.
VCater supply is turned off.
Controls are not set properly.
Lid _sopen
This is normal. Press the POWER button to turn
the washer on.
Make sure cord is plugged securely into a
working outlet.
Turn both hot and coid faucets fully on,
Make sure the cycle was set correctly, close the
lid and press the START/PAUSE button.
Washer not filling
Circuit breaker/fuse is tripped/blown.
Control needs to be reset.
START/PAUSE was not pressed after a cycle
was set,
E×tremely Jaw water pressure,
"Washer is too cold.
Filter dogged,
Inlet hoses may be k{nked
Energy emciency.
tnsumcient water supply.
The washer Hd is open,
Hot and cold inlet hoses are reversed.
"Water _evel is too low,
on a dedicated branch circuit. The washer will
resume the cycle where it stopped once power
is restored.
Press the POWER button, then re-select the
desired cycle and press the START/PAUSE
bufon.
Press the POWER button then re-select the
Check another faucet in the house to make sure
that household water pressure _sadequate.
Make sure the in:let filters on the _tl valves
are not clogged. Refer to the filter cleaning
instructions.
Check that iniet h oses are not kinked or
clogged.
Make sure that both hot and cold water faucets
are turned on oil the way,
Check in_et hose connections. Make sure the hot
cold inlet valve.
29