Cycle Modifier Buttons - Kenmore 796.3146 Series Use & Care Manual

CONTROL PANEL FEATURES
O
O
POWER (ON/OFF) BUTTON
Press to turn the washer ON. Press again to turn
the washer OFF. Pressing _e POWER bu_on dur-
ing a cycle wtl cancel that cycle and any load
settings wll be lost. The ld wil unlock after a
brief pause,
NOTE: ff the washer remains idle for four minutes
offer turning the washer off, any water left in
the tub will automatlcaly _ drained. An alarm
wll sound one minute prior to draining, and 'dr _
wlJ appear on the display. You may restart the
washer at this time. However, once the washer
initiates draining, al functions wll be suspended
and cycle settings lost, and 'dr' will be displayed
until draining is complete.
CYCLE SELECTOR BUTTON
Press _e cycle button to _J_ the desired cyde. Press
• e Specialties b_ repeatedly to cyde thigh
the specialty c_le_ Or_:e tk_ desired cycle has been
selected, the standard prese_ will appear in the dis-
play. These settings can be adjusted using the cycle
setting buttons any time before starting the cycle.
START/PAUSE BUTTON
Press this button to start the selected cycle
If the washer is running, use this button to pause the
cycle without losing the current settings.
NOTE: If you do not press the START/PAUSE button
within four minutes of seiecting a cycle, the washer
automatlcaly turns OFE if the washer is paused
during a cycle for more than four minutes, the cycle
will be cancelled and any water remaining in the
tub will be drained, An alarm will sound at three
minutes to warn you that the tub is about to drain.
_'CYCLE MODIFIER BUTTONS
Use these buffons to adjust the settings for _e se-
lected cycle, The settings light up above the
buttons to show the current selection.
A
SPECIAL CYCLE AND OPTION BUTTONS
These buttons allow you to select specla_ cycles or
options.
TIME AND STATUS DISPLAY
The display shows the cycle sta_s and estimated
time remaining.
NOTE: To prot_ your clothing, not all settings are available on all! cycle selections,
1_ 2