Table of Contents
Advertisement
Pneumatic agitator RL 72
Example for safety instructions in operating instructions
Safety instructions can refer to specific, individual operating instructions. Such safety instructions
are embedded in the operating instructions so that they do not disrupt the reading flow during the
execution of the action. The signal words described above are used.
1.
Unfasten screw.
2.
CAUTION!
Pinching hazard at the cover!
Carefully close cover.
3.
Tighten screw.
Special safety instructions
The following symbols are used in safety instructions to draw the attention to specific hazards:
Warning signs
Additional identifications
The following symbols are used in this manual to highlight operating instructions, results, lists, ref-
erences, and other elements:
Identification
ð
[Pushbuttons]
'Display'
2.2
Personnel requirements
This manual identifies the qualifications of the personnel for the different scopes of work as listed
below:
Operator
The operator has been instructed by the system owner in an orientation session on the assigned
tasks and possible dangers in case of improper behaviour. Tasks that go beyond the operation in
standard mode must only be carried out by the operator if such is indicated in this manual and the
operate has explicitly been tasked to do so.
Article no. ■ 200-0356
Type of danger
Warning – danger zone.
Explanation
Step-by-step instructions
Results of procedural steps
References to sections in this manual and other applicable docu-
ments
Lists without specified order
Operating elements (e.g. pushbuttons, switches), display ele-
ments (e.g. signal lights)
Screen elements (e.g. pushbuttons, assignment of function keys)
ENGLISH
GB–7
Advertisement
Table of Contents
