Pneumatic agitator RL 72
5.2
Install agitator
Fig. 2: Installation
1.
Ensure that the sealing ( Fig. 2/1) is intact and sits properly on the gear box housing (
Fig. 2/2).
2.
Insert gear box housing ( Fig. 2/2) from the top through the cover ( Fig. 2/3).
3.
Once again check position and condition of the sealing ( Fig. 2/1).
Fig. 3: Installation
4.
Mount the agitator on the cover ( Fig. 3/1). For this purpose, screw the nut ( Fig. 3/2) onto
the gear box housing ( Fig. 3/3) (tightening torque:
on page 39.
5.
Tightly screw the coupling part ( Fig. 3/6) to the actuating shaft ( Fig. 3/4) using the
threaded pin ( Fig. 3/5).
Article no. ■ 200-0356
Ä Chapter 12 'Technical data'
ENGLISH
GB–15