Installation, Operation and Maintenance Manual
VCIOM-15792-EN Rev. 0
Figure 15
If the index (Figure 16), does not signal the proper position of the valve but is turned by 90°:
•
•
•
NOTICE
End of stroke micro-switches should be operated before the stop of the stroke of the
actuator due to mechanical stops. Adjust the relative cams properly.
Figure 16
Positon indicator
Operation and Use
Cam adjustment
Remove the roll pin placed on the position indicator (index).
Turn the indicator until reaching its proper positioning.
Put the roll pin back in its position.
Position indicator and pin for micro-switches box
(index)
Section 3: Operation and Use
October 2020
Pin
21