Tools And Supplies Needed; Inspect Appliance And Components - Vermont Castings MONTPELIER II MONTP-II-CB Installation Manual

!
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth &
Home Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance
all components.
• Operating appliance without legs attached (if supplied
with unit).
• Do NOT Over fire - If appliance or chimney connector
glows, you are over firing.
Any such action that may cause a fire hazard.
D. Tools And Supplies Needed
Before beginning the installation be sure the following tools
and building supplies are available:
• Reciprocating saw
• Framing material
• Pliers
• High temp caulking material
• Hammer
• Gloves
• Phillips screwdriver
• Framing square
• Flat blade screwdriver
• Electric drill and bits
• Plumb line
• Safety glasses
• Level
• Tape measure
• Misc. screws and nails
• 7/16 socket or wrench
• 1/2-3/4 in. length, #6 or #8 self-drilling screws
6
WARNING
without fully assembling
E. Inspect Appliance and Components
• Remove appliance and components from packaging
and inspect for damage.
• Vent system components and doors are shipped in
separate packages.
• Report to your dealer any parts damaged in shipment.
• Read all the instructions before starting the installation.
Follow these instructions carefully during the installation
to ensure maximum safety and benefit.
Fire Risk.
Inspect appliance and components for damage.
Damaged parts may impair safe operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
7101-802G
!
WARNING
07/20