Stopping The Machine; Adjusting The Flow Baffle - Toro 30672 Operator's Manual

1. Lower control
bar—engaged and the
machine going reverse
2. Pull up to assist the
machine.
Driving Backward up a Curb
1. Disengage the mower blades.
2. Select the R
EVERSE
machine.
3. Drive the machine until the drive wheels contact
the curb (Figure
Note:
Both drive wheels should contact the
curb and the caster wheels should be straight.
4. At the same time, engage the lower control bar
and lift up the lower handle
10).
Note:
Lifting up the lower handle assists with
driving the machine up a curb and not spinning
the drive wheels.
Figure 9
3. Lower control
bar—engaged and the
machine going forward
position to drive the
9).
(Figure 9 and
1. Lower control
bar—engaged
g000211

Stopping the Machine

CAUTION
You or bystanders may be injured if you move
or attempt to operate the machine while it is
unattended.
Always remove the ignition key and engage
the parking brake if you leave the machine
unattended.
1. Pull back the upper control bar and release the
blade-control bail.
2. Engage the parking brake.
3. Turn the ignition key to the O
Figure
remove the key.

Adjusting the Flow Baffle

You can adjust the mower discharge flow for different
types of mowing conditions. Position the cam lock
and baffle for the best quality of cut.
1. Disengage the PTO and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the nut
4. Adjust the baffle and nut in the slot to the desired
discharge flow.
5. Tighten the nut.
17
Figure 10
2. Handle
position and
FF
(Figure 11).
g001452