Toro 30672 Operator's Manual page 20

Figure 16
1. Axle-pivot bolt
4. Place a jack under the rear center of the engine
frame. Raise the rear end of the engine frame
up enough to remove the front 2 axle-adjustment
bolts (Figure 16).
Note:
Use jack stands to support the machine.
5. Raise or lower the engine frame with the jack so
that you can install the front 2 axle-adjustment
bolts in the desired hole location
Note:
Use a tapered punch to help align the
holes.
6. Tighten all 4 bolts and lower the machine.
7. Adjust the control rods and brake linkages as
required; refer to Adjusting the Control Rods
(page 21) and Adjusting the Parking Brake
(page 33).
Important:
You must adjust the control rods
and brake linkage when you change the
axle positions for proper traction and brake
function.
g001455
2. Axle-adjustment bolt
(Figure 16).
Adjusting the Caster Position
1. Using the Height-of-Cut Chart (page
the caster spacers to match with the axle hole
selected (Figure
1. Latch pin
2. Spacer (5 mm or 3/16 inch)
2. Remove the latch pin, slide the caster from the
support, and change the spacers
3. Install the caster in the support and insert the
latch pin (Figure
20
22), adjust
17).
Figure 17
3. Spacer (13 mm or 1/2 inch)
(Figure
17).
g001456
17).