Powering Off The Press - Xerox Adaptive CMYK+ Kit Reference Manual

Powering Off the Press

Note: Before powering off the press, ensure that there are no active jobs.
1. Before powering off the press, wait approximately 60 seconds to exit the power saver mode.
2. To power off the press, press the Power On/Off button on the right side of the top front panel.
3. Before proceeding to the next step, wait for the power saver indicator to stop blinking.
Note: To power off the press, do not use the main power switch.
Caution: Unplugging the power cord with the main power on can damage the press
internal hard drive or cause a press malfunction.
Caution: Powering off the main power immediately after powering on the main power can
damage the press internal hard drive or cause a press malfunction.
Caution: Powering off the main power immediately after pressing the Power On/Off button
can damage the press internal hard drive or cause a press malfunction.
Caution: Powering off the main power while a job is processing or while the Energy Saver
indicator is blinking can damage the press internal hard drive or cause a press malfunction.
4. To power off the main switch, open the front door, then press the main power switch to the Off
position.
5. Close the front door.
6. Disconnect the power cable from the electrical outlet to the press.
Xerox ® Adaptive CMYK+ Kit for the Xerox
Replacing a Toner Kit
® Versant ® 180 Press
Accessory Reference Guide
25