Equinox Systems Highlander XL TRF Assembly Instructions & Operations Handbook page 5

NOTE: Make sure the Frame Support Brackets are correctly
aligned on the Body before drilling.
For the hole in the Frame Support Bracket marked position
C in figure 3, use a 10 mm drill bit to drill a hole through the
plastic body. Reach inside the body and insert an
M10 x 25 mm Carriage Bolt through the newly drilled hole.
2G
Repeat the steps 2E and 2F at the holes in the Frame Support Brackets marked positions D, E and F in figure 3 above,
drilling a hole and attaching a Carriage Bolt, Washer and Lock Nut. Make sure each time that the Brackets are still
aligned with the moulded lines in the body before drilling.
2E
IMPORTANT:
2H
Now tighten all 6 of the Nuts holding the Axle to the
Frame Assembly Brackets (from Stage 1).
Your
assembly
should now
look like this.
On the outside of the Body/Frame Support Bracket place an
M10 washer on the bolt and secure with an M10 Lock Nut.
TIP: You can hold the Carriage Bolt on the underside using
the tip of a pair of pliers.
2F