Advertisement
Stage 2: Attaching Frame to Body
For this stage you will require:
(1) Frame Assembly (from Stage 1)
(6) M10 Washers
Turn the Highlander body upside
down to begin installation.
2A
FIGURE 2
2B
NOTE: Make sure the Frame Assembly is correctly aligned on
the Body before drilling.
For the hole in the Channel marked position A in figure 3
above, use a 10 mm drill bit to drill a hole through the plastic
body. Reach inside the body and insert an M10 x 25 mm
Carriage Bolt through the newly drilled hole.
2D
Repeat steps 2B and 2C at the hole in the Channel marked position B in figure 3 above, drilling a hole and attaching a
Carriage Bolt, Washer and Lock Nut.
(1) Body
FIGURE 1
(6) M10 Lock Nuts
FIGURE 1
Place the frame assembly on the body.
Align the back centre of the frame to the raised rectangular ridge moulded into the Body
(see figure 1 above). Align the front and back Frame Support Brackets to be parallel to the
moulded lines in the Body (see figure 2 above).
(6) M10 x 25 mm Carriage Bolts
FIGURE 3
D
C
2C
On the outside of the Body/Channel place an M10 washer
on to the Bolt and secure with an M10 Lock Nut. Tighten
Lock Nut.
TIP: You can hold the Carriage Bolt on the underside using
the tip of a pair of pliers.
B
F
A
E
Advertisement
