Advertisement
Stage 3: Attaching Wheels
For this stage you will require:
(1) Frame Assembly (from previous stage)
(2) Cotter Pins
FIGURE 9
Place wheels on each spindle with
the grease nipple facing inwards.
Install cotter pin through the hole in the
end of the axle for both wheels (see fig
10).
Stage 4: Attaching Hitch
For this stage you will require:
(1) Completed Assembly (from previous stage)
(1) Tipper Latch
(3) M12 Lock Nuts
(2) M10 Lock Nuts
4A
Place the hitch bar so that the beveled
edge faces down and towards the
back of the unit. Secure in place using
an M12 x 85 mm hex head bolt, 4 M12
washers and an M12 locknut.
NOTE: Washers are used on the outside
of both sides of the Channel as well as
in between Channel and the Hitch Bar.
(2) Tire and Rim
FIGURE 10
Ensure both tabs of the cotter pins are separated after placement.
Finally, grease wheel bearings with a grease gun, using grease nipples on the
inside of each wheel.
(1) Hitch Bar)
(3) M12 x 85 mm Hex Head Bolts
(2) M10 x 70 mm Hex Head Bolts
4B
Secure the Ball Coupler in place using
two M12 x 85 mm Hex Head Bolts and
two M12 Lock Nuts.
FIGURE 11
(1) Ball Coupler
(4) M12 Washers
(2) M10 Washers
4C
Using two M10 x 70 mm Hex Head
Bolts, two M10 Washers and two M10
Lock Nuts secure the tipper latch
in place.
Advertisement
