The purpose of this document is to provide guidelines and help for installers and fabricators
working with the Planar
replace the User Manual or the Content Developer's Guide. It does not provide specifics on how
to work in each environment where a Planar LookThru display may be installed. This document
is intended to provide expert fabricators and installers with the information and understanding
necessary to make the most of the Planar LookThru display.
Detailed specification and instructions on operating the Planar LookThru display are found in the
User Manual located at www.planar.com/LookThru.
What's in the Box
Standard Model
Cable Cover
Due to the orientation of the circuit boards in the Electronics Box, it is
asymmetrical when compared to the Display Chassis. The Cable
Cover makes the Electronics Box symmetrical without restricting
access to the I/O ports.
Note: Never use the Cable Cover to lift or move the display
HDMI and Power Cables
The Planar LookThru display ships with a 110VAC power cable with
C14 connector and one HDMI cable. The display has four HDMI
ports (2x 2.0 and 2x 1.4), one DisplayPort input (1.2), one
DisplayPort output, as well as connections for RS-232 controllers, LAN, USB and the infrared
sensor.
3
®
LookThru™ Transparent OLED Display. This document does not
Display
Planar LookThru displays come in two models (described
in detail in the next section) and both models have three
main components: Display Glass, Display Chassis and
Electronics Box. The Display Chassis is the main support
for the entire display and should be used when removing
the display from the box, moving it or mounting it during
installation.
Counterweight Plate
The Counterweight Plate serves as a stabilizer and ships
attached to the Electronics Box on Standard Models
(more information on models later). The Counterweight
Plate should be removed if the Planar LookThru display
will be mounted to a fixture or surface.
Planar LookThru Fabricator's Guide
020-1315-00C