Planar LookThru Fabricator’s Manual page 13

The primary mounting points are on the Display Chassis and at least three of five primary
mounting points must be used when mounting the Planar LookThru display. Ideally, all five
should be used, but when there is no suitable mounting substrate it is permissible to augment
the primary mounting points with the secondary mounting points located on the Electronics Box.
Standard Design Mounting Points (LO552)
Never use only secondary mounting points. Every installation must use a minimum of three
primary mounting points.
Both the primary and secondary mounting points receive M6 threaded mounting screws.
If there is insufficient support on the mounting surface (e.g. the wall studs do not align with the
mounting points) the optional base plate can be used to aid in mounting the Planar LookThru
display. The base plate can be secured to the mounting surface and then the display secured to
the mounting points on the Base Plate that are aligned with the mounting points on the display.
Any leveling that needs to be done to align the Display Glass with the rest of the installation
should be done via the mounting points and/or the base plate. No pressure should be placed on
the glass to move it into position, rather the Display Chassis and Electronics Box should be
moved to affect the desired movement in the Display Glass.
Multiple Planar LookThru displays
can be arranged in a tiled installation
using the optional tiling components.
The optional tiling components are
connectors that clip the corners of
the Display Glass together to prevent
movement.
13
Straight Mount Design Mounting Points (LO552-S)
Planar LookThru Fabricator's Guide
Portrait corner tile set-up (LO552's)
020-1315-00C