Pentair Pool Products Kreepy krauly Platinum LL505PM Installation And User Manual page 13

Example of Hose Assembly Before Cutting to Hose Length
1. With the feed hose assembly attached to the pool wall, hold the feed hose assembly by the
opposite end with the clear hose and walk the perimeter of the pool to locate the farthest
point on the perimeter from the wall fi tting without stretching the hose assembly.
2. Measure the distance that the hose assembly extends beyond the pool perimeter
farthest point located in Step 1 — (7½ ft. in this example).
3. Cut half of the length obtained from Step 2 — (3¾ ft. in this example), equally from each of
the 10 foot lengths of white or grey hose on either side of the marked swivel.
WHITE OR GREY
HOSE SECTION
MARKED SWIVEL
4. Reassemble the hoses using the supplied mender nuts as shown in FIGURE 1.
5. The complete hose assembly should look like this. The end of the 30 inch clear hose should
reach just to the furthest edge of the pool perimeter as shown.
MARKED SWIVEL
SOFT HOSE
(Cut to your pool depth)
BACK UP VALVE
WALL FITTING
SWIVEL
FLOATS
10 FOOT
FLOATS
10 FOOT
WHITE OR GREY
HOSE SECTION
10 FOOT
SOFT HOSE
FARTHEST POINT OF POOL PERIMETER
FROM WALL FITTING
WHITE OR GREY
HARD HOSE SECTION
WHITE OR GREY
HARD HOSE SECTION
REMOVE EXCESS MATERIAL
FROM HOSE ON EITHER SIDE OF
MARKED SWIVEL AS DESCRIBED
IN STEPS 2 AND 3.
SWIVEL
FLOATS
BACK UP
VALVE
7½ FT.
EXAMPLE DIMENSION
(Your Measurement May Differ)
NOT TO SCALE
WHITE OR GREY
HARD HOSE SECTION
(WALL FITTING SIDE)
MARKED SWIVEL
WHITE OR GREY
HARD HOSE SECTION
(CLEANER SIDE)
END OF
SOFT HOSE
(End remains 30 in.)
FURTHEST POINT
OF POOL PERIMETER
FROM WALL FITTING
Kreepy Krauly ® Platinum ™
FIGURE 1
Installation and User's Guide
5