Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
INSTRUCTIONS
Remove Transport System
WARNING
Excessive Weight Hazard
Use two or more people to move and install
washer.
Failure to do so can result in back or other injury.
IMPORTANT: Position the washer so that the rear of the unit
is within approximately 3 ft (90 cm) of the final location.
There are 4 bolts in the rear panel of the washer that support the
suspension system during transportation.
1. Using a ½ in. (13 mm) wrench, loosen each of the bolts.
2. Once the bolt is loose, move it to the center of the hole and
completely pull out the bolt, including the plastic spacer
covering the bolt and the cable attached to the bolt. The
power cord will be attached to all 4 bolts.
3. Once all 4 bolts are removed, remove the power cord from
each bolt holder, and discard bolts, plastic spacers, and
cables.
4. Close the holes with the transport bolt hole plugs.
HOT
COLD
Connect the Inlet Hoses
Connect the inlet hoses to the water faucets
Make sure the washer drum is empty.
1. Attach the hose with the red color indicator to the hot water
faucet. Screw on coupling by hand until it is seated on the
washer.
2. Attach the hose with the blue color indicator to the cold water
faucet. Screw on coupling by hand until it is seated on the
washer.
3. Using pliers, tighten the couplings with an additional two-
thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
4. Turn on the water faucets and check for leaks.
NOTE: Replace inlet hoses after 5 years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
Route the Drain Hose
Proper routing of the drain hose protects your floors from
damage due to water leakage. Carefully read and follow these
instructions.
The drain hose is connected to your washer.
To prevent drain water from going back into the washer:
Do not straighten the drain hose, and do not force excess
drain hose into standpipe. Hose should be secure, but loose
enough to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
Floor drain
You may need additional parts. (See Floor Drain under "Alternate
Parts You May Need.")
7
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the duet Front-Load Washer and is the answer not in the manual?
Questions and answers
where is and how to clean lint trap whirlpool duet frontend loader
How to use the spin cycle only
To use the spin cycle only on a Whirlpool Duet Front-Load Washer, follow these steps:
1. Select PAUSE/CANCEL to stop any current cycle.
2. Select DRAIN/SPIN on the control panel.
3. Press and hold HOLD TO START for about 1 second to begin the spin cycle.
4. When the spin is complete, the door will unlock, and you can remove the items.
If needed, you can reduce the spin speed by selecting the desired speed from the SPIN SPEED modifier.
This answer is automatically generated
is there a way to have a shorter cycle than 27 minutes? Please instruct.
The Whirlpool Duet Front-Load Washer has a Quick Wash cycle designed for loads that are needed in a hurry. This cycle combines fast-speed tumbling, a shortened wash time, and high-speed spin to shorten drying time. However, the exact duration of the Quick Wash cycle is not specified in the provided information. If the Quick Wash cycle is shorter than 27 minutes, then the washer can have a shorter cycle.
This answer is automatically generated