Table of Contents
Advertisement
RC-Link
when doing without a connection to the RC-Link to the rails, you have
to plug-in the included jumper:
version with USB-port: JP1
version with V24-port: JP2
In case the jumper has not been plugged-in, the RC-Link suppresses
the transfer of disengaged reports.
7. Programming the detectors´ addresses
You can use the PC to program the addresses of the connected
detectors (no. 1 to 24) via the RC-Link. You need a special software for
that (e.g. PC-RC on the included CD). Proceed as follows:
Put the detector you intend to program into the programming mode
as described in the detector´s manual.
Start the software and proceed according the instructions.
Finish the programming mode for the detector as described in its
manual.
In order to program the addresses of further detectors, repeat the
described procedure.
English
Page 15
Advertisement
Table of Contents
