Operation - GRE HIMVCB50.18 Instruction Manual

6.2 The steps of changing the battery
(1) Push the button "a" forward along the arrow direction, until it not stuck the slot of the connector.(as
picture "A" shows)
(2) Holding the body while reversing the connector , and removing the battery mounting from the
body.( as "b1" in picture "B" shows)
Note: Please don't pull the battery group heavily , and unlock the battery and the fastener,Fig[ b2]
(3) Remove the used battery, and replace new lithium battery. Connect the battery and the fastener in
the battery holder first, see the place "c1" on picture "C", then put in the battery.
Note: The battery should be in right place, about 10mm from the connection port, the wire in the
unoccupied place of the side. (see "c2" in picture "C")
(4) Twist the connector into the body in clockwise, until the button "a" can buckle in the slot of
connector. As picture "D" shows.
(5) Now you can use the cleaner according to the instruction normally.
A

7. Operation

WARNING!
Do not use the cleaner if any damage is found.
Pollution of the liquid could occur due to leakage of lubricants.
Do not operate this cleaner when people/pets are in the water.
Be sure the cleaner is fully immersed in the water before operating. DO NOT operate it outside of water.
It will lead to failure of the shaft seals/motor, and then VOID the warranty.
DO NOT use the cleaner without intact filter sock and sleeve in place. Using you cleaner without intact
filter sock and sleeve in place will VOID your warranty.
Risk of Suction Entrapment Hazard. This cleaner generates suction. Avoid hair, body or any loose parts
of your clothing to contact with the suction hole of the cleaner in operation.
Never insert body parts, clothing or other objects into the openings and moving parts of the cleaner.
DO NOT use this cleaner to pick up any toxic substance, flammable or combustible liquids such as
gasoline, or operate in the presence of explosive or flammable fumes.
CAUTION!
Use original accessories delivered with this product .
DO NOT use this cleaner immediately after pool shocking. It is recommended to leave the pool
circulating for at least 24-48 hours.
DO NOT leave the cleaner in the water when not in use.
The transparent suction part should be well installed before your powering the electric cleaner. (the
transparent suction part has the button protection system in case the impeller will get your hands hurt).
b1 b2 C1
B
C2
C D