Operation - GRE VCB10 Instruction Manual

Suction head assembly
lnsert the Suction Head directly to the suction hole of the cleaner tightly by hand.
In order to have the better suction effect,
please operate the electric cleaner as the
following instructions:
(1) lnsert the suction head when suction the
small pebbles and leaves, as the Picture A
shows.
(2) No need to insert the suction head onto
the electric cleaner when suction the
stones and other large garbage and so on,
as the Picture B shows.
Brushes on the Suction Head can be removed by pulling out directly from the head.
For Vinyl, liner and fibreglass pools, it is recommended to keep the brushes on
the suction head to prevent damage to your pool.
Cleaning the cleaner after using the electric cleaner:
(1) Take the transparent body off the electric
cleaner (following the OPEN-GLOSE direction,
rotate to OPEN direction 90 degrees), and
take the garbage out of the transparent body,
and then clean it.)
(2) Take out the rear part of filter bag, and take
out the filter bag, and get out the garbage, and
then clean the filter bag.
The cleaning steps of filter bag
1. Pull out the basket and filter bag from the rear of pool cleaner;
2. Detach the filter bag from the filter basket;
3. Clean the filter bag and filter basket
(3) Check whether there is garbage on the impeller. lf it has, take out the
garbage, and clean the impeller.

OPERATION

Warning
Do not use the cleaner if any damage is found.
Pollution of the liquid could occur due to leakage of lubricants.
Do not operate this cleaner when people/pets are in the water.
Make sure the cleaner is fully immersed in the water before operating. DO
5