Table of Contents
Advertisement
2. After installation of the printer driver and SmartCONTROL Vision software, please connect the USB cable
between computer and the laser machine
3. Connect the 2nd USB cable between computer and the SmartVISION
4.1.2.2 Ethernet Connectivity
Connect the Ethernet Cable in accessory to the Ethernet port on the right-hand side of the laser system. Follow
below instruction for Ethernet connectivity setup.
NOTE
1.
Never leave laser system unattended during laser cutting, engraving, and marking process, even
with Ethernet or Wi-Fi connection setup, this requirement cannot be avoided. Exposure to the
laser beam may cause ignition flame to combustible materials.
2.
DO NOT connect USB cable when using Ethernet function for data transmission.
3.
If you have purchased additional Optional Accessories for the LV-290, please refer to chapter 7
for instructions on how to properly setup your optional accessories. These should be setup prior
to working with your LV-290.
TM
Pro CCD connection port
29
Advertisement
Table of Contents
