Table of Contents
Advertisement
enable the mouse when the PC is initially booted.
If you have switched off your AdderView DVI or you are attempting to 'hot plug' it
into a system that is already running, you may be able to restore lost mouse
movement using the AdderView DVI's mouse restoration functions.
Mouse restoration functions should be used with care as unpredictable
results may occur if the wrong mouse type is selected. If in doubt restore the
mouse by powering down the PC normally.
Standard PS/2 mouse data uses a different data format to IntelliMouse data and so
two reset functions are provided on the AdderView DVI. The type of data format
expected by the PC depends upon the driver and the type of mouse that was
connected when the driver was booted. The following table may be used as a guide.
Note that the mouse reset functions predict the likely mouse resolution settings but
may not restore the speed or sensitivity of the mouse exactly as they were when the
PC originally booted.
Type of mouse / system
Connected at bootup
PS/2
PS/2
IntelliMouse / AdderView DVI
IntelliMouse / AdderView DVI
To restore lost mouse movement on a CPU connected to the AdderView DVI:
1) Select the CPU that has lost its mouse movement
2) Press the select key on the front of the AdderView DVI for 5 seconds until 'C' is
displayed. You are now in configure mode.
3) To restore a PS/2 mouse connection press
Or, to restore an IntelliMouse connection press
AdderView DVI
Driver type Likely expected
PS/2 only
IntelliMouse
PS/2 only
IntelliMouse
F 5 f
F 5
F 6 f
F 6
Installation and Use
data format
PS/2
PS/2
PS/2
IntelliMouse
f
f
Suggested
restoration
F5
F5
F5
F6
Page 17
Advertisement
Table of Contents
