Setup; Pressure Relief Procedure - Graco 24S134 Operation, Parts

Setup

Setup
Air hose fittings can get hot! Allow sprayer
to cool down 15 minutes before removing
air hose.
1. Connect air and material hoses to gun.
Firmly tighten connections.
ti28143a
2. If using WideTex adapter, install disc (2)
on front of adapter (3) with retaining ring
(1). Install a standard nozzle (4) on front
of gun with the assembly. Pulling trigger
when installing nozzle makes assembly
easier. If desired finish is not achieved,
try a different size standard nozzle. See
Recommended Nozzle & Disc
Selection Charts, page 7.
3
2
1
ti28087a
3. For Standard operation: install nozzle
(4) on front of gun and secure using
retaining ring (5). See Recommended
Nozzle & Disc Selection Charts, page
7. Pulling trigger when installing nozzle
makes assembly easier.
6
4
4
5
ti28086a
4. Refer to sprayer operation manual to
start and prime the sprayer.

Pressure Relief Procedure

Follow the Pressure Relief
Procedure whenever you see this
symbol.
This equipment stays pressurized until
pressure is manually relieved. To help
prevent serious injury from pressurized
fluid and splashed fluid follow the
Pressure Relief Procedure whenever
sprayer is stopped and before sprayer is
cleaned or checked, and before equipment
is serviced.
1. Turn ON/OFF switch to the OFF
position. Wait 7 seconds for power to
dissipate.
2. Unplug sprayer.
3. Turn fluid regulator all the way down.
4. Shut OFF air source.
5. Aim gun into hopper or waste bucket and
trigger the gun until all air and material
pressure is relieved. or open Prime
Valve.
3A3373C