Kyocera TJEP Manual page 11

Troubleshooting
Symptom
Nailer operates normally
but does not drive the
fasteners to flush.
The fasteners is driven to
flush at normal speed, but
when increasing speed it is
not driven to flush.
The fastener is driven too
deeply into the work piece.
A fasteners is jammed.
Tool operates normally, but
no fasteners is driven.
If you cannot solve the problem, the nailer must be sent to your TJEP dealer. Never use a damaged nailer.
Repairs must be performed only by professionals trained in the repair of TJEP nailers.
Solution
Adjust the depth of drive setting to the deepest. Maximise the air pressure (max
pressure is specified on the nailer)
The wood is too hard for the chosen length of fasteners
Maximise the air pressure (max pressure is specified on the nailer)
Use an air supply hose with a larger inner diameter.
Use a shorter air supply hose.
Move the nozzle downwards to reduce the driving depth.
Reduce the air pressure.
Remove the air supply. Remove the jammed fastener.
Make sure that the fasteners are placed correctly in the magazine. The fasteners
must be able to move freely back and forth. If necessary, clean the magazine for
any possible remains or jammed fasteners. Make sure that the airsupply is suf-
ficient. Use only fasteners recommended by the producer.
English
11