Table of Contents
Advertisement
PETSPY ADVANCED DUAL DOG TRAINING COLLAR OPERATION GUIDE
Preparing Remote Transmitter for your first use:
•Please charge the Remote Transmitter for approximately 30 minutes.
•The Charging Port is located on the top of the transmitter (next to antenna).
•During the charge, the Battery Indicator icon will be flashing. When the battery is fully
charged the indicator will turn solid, notifying you that the charging is completed.
REMOTE TRANSMITTER OPERATION
1. Press the Power Button to turn on the remote. Press and hold the Power Button for
about 3 seconds to turn it off.
2. You can select which Receiver is being controlled (A, B, or A&B) by pressing the
Menu/Mode Button.
3. Press the Vibration Button to deliver the Vibration Stimulation to your dog.
4. Press the Static Shock Button to deliver the Static Shock Stimulation to your dog.
5. Press the Receiver Tone Button to deliver beeping noise to your dog during the
Sound Training.
6. The Remote Transmitter will enter into Standby Mode if not operated for 2 minutes
and will turn Off after 5 minutes.
7. In Standby Mode, press Menu/Mode Button to wake the Transmitter up.
REMOTE TRANSMITTER PROGRAMMING
1. Turn ON the Remote Transmitter by pressing the Power Button
2. Press and Hold the Menu/Mode Button for 3 seconds until you hear a beep to enter
the Programming Mode. The Receiver to be programmed (A, B, or A&B) will start
flashing. If Receiver A is flashing, but you would like to program Receiver B or both Re-
ceivers A&B, simply use 2 Tone Buttons (upper left and upper right) to switch between
the Receivers.
3. When desired Receiver is selected to be programmed (A, B, or A&B), press Menu/
Mode Button to start setting it up. The setup process starts with the Receiver Tone
Level. Use 2 Tone Buttons (upper left and upper right) to adjust its Level and then press
Menu/Mode Button to confirm. Next, it will take you to the Vibration Intensity Level
setup, Static Shock Intensity Level setup, and finally to the Transmitter Tone Level
setup.
4. When Programming is complete, press and hold Menu/Mode button to save your
settings.
5. You can repeat Steps 2-4 to program Receiver A, Receiver B, or both Receivers A&B.
- Quick Links:
- Remote Transmitter Operation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the M86N and is the answer not in the manual?
Questions and answers
green light on collar will not go off, cannot pair with remote
The provided context does not mention a green light on the PetSpy M86N collar. However, to pair the collar with the remote, follow these steps:
1. Ensure both the Transmitter and Receiver are fully charged and turned on.
2. Press and hold the Power button on the Receiver Collar for about 5 seconds until it enters Synchronization Mode (indicated by a beep and fast flashing red LED).
3. While the red LED is flashing, send a correction command from the remote (such as Vibration) by pressing and holding the corresponding button until the collar responds.
If the green light issue persists, further troubleshooting may be required.
This answer is automatically generated