Table of Contents
Advertisement
TERMS OF USE AND LIMITATION OF LIABILITY
1. Terms of Use
This Product is designed to be used with dogs where training is desired. The specific
temperament of your dog may not work with the product. We do not recommend you
to use this product if your pet is less than 8 lbs or under 6 months old, or if your pet
is aggressive. If you are unsure whether this is appropriate for your pet, please consult
your veterinarian, or a certified trainer. Proper use includes reviewing the entire User
Manual and Dog Training Guide provided with the product. Pay extra attention to all
Caution statements.
2. No Unlawful or Prohibited Use
This Product is designed for use with dogs only. PetSpy dog training collar is not
intended to harm, injure, or provoke. Using this product in a way that is not intended
could result in violation of Federal, State or local laws.
3. Limitation of Liability
In no event shall we be liable for any direct, indirect, punitive, incidental, special or
consequential damages, or any damages whatsoever arising out of or connected with
the use or misuse of this Product. Buyer assumes all risks and liability from the use of
this Product.
4. Modification of Terms and Conditions
We reserve the right to change the terms, conditions and notices under which this
Product is offered.
WARRANTY
PetSpy Dog Training Collar comes with a Limited 1-Year Warranty . If you ever have
any issue with your training collar - please send us an email and we will be happy to
assist you! We also offer an extended customer support program.
support@petspystore.com
PETSPY INC, 2015-2017
- Quick Links:
- Remote Transmitter Operation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the M86N and is the answer not in the manual?
Questions and answers
green light on collar will not go off, cannot pair with remote
The provided context does not mention a green light on the PetSpy M86N collar. However, to pair the collar with the remote, follow these steps:
1. Ensure both the Transmitter and Receiver are fully charged and turned on.
2. Press and hold the Power button on the Receiver Collar for about 5 seconds until it enters Synchronization Mode (indicated by a beep and fast flashing red LED).
3. While the red LED is flashing, send a correction command from the remote (such as Vibration) by pressing and holding the corresponding button until the collar responds.
If the green light issue persists, further troubleshooting may be required.
This answer is automatically generated