Do you have a question about the M86N and is the answer not in the manual?
Questions and answers
Saundra Lambert
March 21, 2025
green light on collar will not go off, cannot pair with remote
1 comments:
Mr. Anderson
March 21, 2025
The provided context does not mention a green light on the PetSpy M86N collar. However, to pair the collar with the remote, follow these steps:
1. Ensure both the Transmitter and Receiver are fully charged and turned on. 2. Press and hold the Power button on the Receiver Collar for about 5 seconds until it enters Synchronization Mode (indicated by a beep and fast flashing red LED). 3. While the red LED is flashing, send a correction command from the remote (such as Vibration) by pressing and holding the corresponding button until the collar responds.
If the green light issue persists, further troubleshooting may be required.
Need help?
Do you have a question about the M86N and is the answer not in the manual?
Questions and answers
green light on collar will not go off, cannot pair with remote
The provided context does not mention a green light on the PetSpy M86N collar. However, to pair the collar with the remote, follow these steps:
1. Ensure both the Transmitter and Receiver are fully charged and turned on.
2. Press and hold the Power button on the Receiver Collar for about 5 seconds until it enters Synchronization Mode (indicated by a beep and fast flashing red LED).
3. While the red LED is flashing, send a correction command from the remote (such as Vibration) by pressing and holding the corresponding button until the collar responds.
If the green light issue persists, further troubleshooting may be required.
This answer is automatically generated