Attach The Control Head To The Base - Humminbird PiranhaMAX 165 Installation And Operation Manual

5. Attach the Control Head to the Base

Follow these steps to attach the control head to the already-assembled base:
NOTE: The transducer cable and power cable should be routed prior to securing the
mounting bracket to the deck.
1. Apply marine-grade silicone sealant to the drilled holes for the
mounting bracket.
2. Place the mounting bracket on the mounting surface, aligning with the
drilled holes.
3. Insert the four #8 Phillips countersink wood screws into the mounting
holes. Hand tighten only!
Gimbal Knob
4. Insert the thumbknob bolt through the pivot knuckle on the control
head (Figure 7).
Fixed Control Head Installation
Figure 7
Pivot Knuckle
Mounting Holes
6
Thumbknob Bolt