Removing The Control Board - Whirlpool JOB AID GC1SHAXM Installation And Operation Manual

REMOVING THE CONTROL BOARD

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug refrigerator or disconnect power.
2. Remove the six screws from the unit com-
partment cover and remove the cover.
Unit Compartment Cover Screws (3 of 6)
3. Remove the two screws from the control
board housing cover and pull the assembly
out of the unit.
Control Board Housing
Cover Screws
4. Using a small screwdriver, start at the top
of the cover, and pry the tabs on the hous-
ing from the loops on the cover. When all
the loops are free, remove the cover.
5. Remove the four screws from the control
board.
6. Disconnect the wire connectors from the
control board and remove it from the hous-
ing.
4 Control Board Screws
4-8
Top Of Housing Cover Open
Wire Connectors