User Interface - Whirlpool JOB AID GC1SHAXM Installation And Operation Manual

The user interface allows the customer to
adjust the temperatures, choose what kind of
ice to be dispensed, and monitor the remain-
ing water filter capacity. There are also lockout
modes for the temperature controls and the ice
and water dispenser. The temperatures are
only displayed in Fahrenheit.
Each function is described below.
ON/OFF—Press the keypad for 2 seconds to
turn the unit on and off.
When the unit is turned "off":
• Only the central decimal point shows in
both temperature displays.
• All functions are disabled.
• All lamps and lights are off.
When the unit is turned "on":
• All functions are restored at power-up.
• Temperature settings before power-
down are remembered.
• Fast Freeze and/or Grocery Savor
mode will be discontinued after power-
up, if selected prior to power-down.
• The compressor will wait 7 minutes to
start.
• The condenser fan will wait 1 minute to
start after the compressor starts.

USER INTERFACE

NOTE: At the first power-up, the control will
start in the following DEFAULT operating
mode:
FREEZER (Temperature Settings)—Adjust-
ment ranges from –5°F to +5°F. Each time the
COLD or COLDER keypad is pressed, the set
temperature will raise or lower 1°F. The display
shows only the set temperature.
REFRIGERATOR (Temperature Settings)—
Adjustment ranges from 33°F to 41°F. Each
time the COLD or COLDER keypad is pressed,
the set temperature will raise or lower 1°F. The
display shows only the set temperature.
FAST FREEZE—Pressing this keypad places
the freezer section into continuous cool-down
mode for 24 hours. The control will then return
to the last freezer set temperature. While in
this mode, the FAST FREEZE keypad is illumi-
nated. Pressing the keypad a second time will
terminate the FAST FREEZE mode. The refrig-
erator section temperature is not affected.
3-2
• Unit is in the "On" state.
• Freezer temperature is set at 0ºF; Re-
frigerator temperature set at 37ºF.
• Self Diagnostic Mode enabled for 10
minutes.
• Ice in Cube mode.
• Dispenser light "off".
• Time to defrost will be set at 30 hours of
compressor run time, or 50 hours actual
time.