Dispenser User Interface (Ui) And Dispenser Components - Whirlpool WRF954CIHV Service Manual

Dispenser User Interface (UI) and Dispenser Components

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Dispenser User Interface (UI)
1. Depress the two tabs under the front of the UI.
2. Remove the five wiring connectors from the UI. Remove the
UI panel.
False Wall
3. Push in the drip tray fully. Lift the front edge and remove the
drip tray.
4. Remove the two 1/4" screws in the dispenser tray slide.
5. Remove the two 1/4" screws in the top of the false wall.
6. Unclip the dispenser water tube from above the water
paddle.
7. Slide the false wall forward and remove from the dispenser
housing.
Water Paddle
8. Note the positioning of the water paddle torsion spring and
remove.
9. Disengage the water paddle from the two plastic retaining
clips and remove.
Water Paddle Limit Switch
10. Disconnect the wiring connector from the water paddle
switch.
11. Remove the switch from the plastic clips holding it in place.
Ice Paddle
1. Remove the UI.
2. Remove the false wall.
3. Note the positioning of the ice paddle torsion spring and
remove it.
4. Remove the two plastic ice paddle pins from the holes in the
plastic housing and remove ice paddle.
Ice Paddle Limit Switch
1. Remove the UI.
2. Remove the False Wall.
3. Disconnect the wiring connector from the ice paddle switch.
4. Remove the switch from the plastic clips holding it in place.
Ice Door Motor Bracket
1. Remove the UI.
2. Remove the False Wall.
3. Remove the two 1/4" screws holding the ice door.
4. Motor Bracket in place, and remove.
Dispenser Heater
1. Remove the UI.
2. Remove the false wall.
3. Remove the ice door motor bracket.
4. Disconnect the wiring connector for the dispenser heater.
French-Door Bottom Mount Refrigerator
COMPONENT ACCESS
n
3-9