Hobie Wave Assembly Manual page 15

4
Check wires to be sure they are not crossed and that they freely allow
the mast to swing to the upright position.
If you are stepping the mast by yourself, or just to make things easier,
pull the sail halyard hook forward, over the top of the shroud wires,
to the bow. Hook into the bridle wire fitting. Loosely tie opposite end
of halyard to the cleat at the bottom end of the mast. This line will be
used to hold mast in the upright position before forestay and bridle
wire assembly are attached to the bow fittings.
5
Stand on the trampoline near the rear crossbar and lift the mast to
your shoulder
Face forward on the boat with a wide stance for stability. Walk forward
while lifting the mast until the side shrouds become tight, preventing
the mast from further forward movement. Lean your weight against
the mast to hold it in this position.
Assembly Required
6
Reach down to the halyard cleat and pull
the halyard line tight. Fasten the line to
the cleat in a secure manner as shown in
"knots" page.
15
hobie.com