Mast Wires - Hobie Wave Assembly Manual

Assembly Required
12

Mast Wires

1
The mast will be held in the upright position by two side wires
(shrouds) and one front wire (forestay). The forestay will attach to two
shorter wires (bridles) with a "7 hole" adjuster. Locate the three main
(longer) wires and install onto the mast tang as shown below using
the 1/4" threaded shackle provided in the rig kit. The shorter forestay
wire goes in the middle of the shackle with one shroud on either side.
5/8" clevis pin and ring
hobie.com
headstay
7 hole stay adjuster
1/4" bell shackle
bridle from bow
mast
mast tang
1/4" bell shackle
shroud
1/2 clevis pin and ring
hull