DPD01156B
Flange Mount Kit for Frame FS7
1
M5 DIN315
M4x12 PZ
M4x8 PZ
3
4
5
6
2
FS7 Flange Mounting
If your drive is Type 1/IP21-protected and there is the risk that dust or other impurities in the cooling air might
end up inside the control unit, start the mounting with actions described in the steps 1 to 5.
If this is not needed, install the flange mounting kit proceeding directly to the step 6. Note, in this case the rear
will not be according to Type 12/IP54.
Remove the cover of the drive. Also
1
remove the fan block plate.
The kit consists of:
1. Top collar, (70CMC00343)
2. Bottom collar, (70CMC00344)
3. Side collars (2 pcs), (70CMC00345)
4. Bushing rubber (1 pcs), (MC00016)
5. Fan grille, (70CTC1102699)
6. Internal fan, (70CPE00173)
Additionally:
10 screws size M4x12 PZ (for the side, top and bottom collars
mounting)
6 screws size M4x8 PZ (for the side collars mounting)
3
1 wing nut size M5 DIN315 (for the fan grille mounting)
1 torx head (for removing screws. See the step 6.)
9274.emf
Siemens Industry, Inc.
9283.emf
23