Advertisement
DPD01156B
Flange Mount Kit for Frame FS6
1
M4x16
M4x12
3
M3.5x10
4
5
6
7
2
FS6 Flange Mounting
If your drive is Type 1/IP21-protected and there is the risk that dust or other impurities in the cooling air might
end up inside the control unit, start the mounting with actions described in the steps 1 to 5.
If this is not needed, install the flange mounting kit proceeding directly to the step 6. Note, in this case the rear
will not be according to Type 12/IP54.
Please read the step 8 first in order to find out if the snaps are needed.
Remove the cover of the driven, and
1
the fan block plate.
The kit consists of:
1. Top collar, (70CMR00174)
2. Bottom collar, (70CMR00173)
3. Side collars (2 pcs), (70CMR00145)
4. Internal fan, (70CPE00056)
5. Sealing plugs (6 pcs), (70CMR00324)
6. Fan grille 50 mm, (70CTC1102509)
7. Snaps (2 pcs), (The snaps can be battered down from the
bottom collar.)
Additionally:
3
• 8 screws size 4x16 (for the top and bottom collar mounting)
• 6 screws size 4x12 (for the side collar mounting)
• 2 screws size 3.5x10 (for the bottom collar mounting)
7
9271.emf
Siemens Industry, Inc.
9296.emf
17
Advertisement
