Panasonic NS-700 Programming Manual

Program an nt type phone

Hide thumbs Also See for NS-700:

Page 1

Panasonic NS-700

Program an NT Type phone

Check that DHCP is On:

Power phone on

When you see SETUP in the LCD, Press the button below SETUP

Use the navigation disk and select Network

Press the button below ENTER

Look at the top of the LCD and be sure DHCP is Enable.

If it isn't, use the Navigation Disk to select Enable.

Press the button below EXIT

If you see "Data's changed!" STORE?

Select YES

------------------------------------------------------------------

Power the phone down (by unplugging it from the wall, for 15 seconds.

Then, Power the phone back on

When you see SETUP in the LCD, press the button below SETUP

Use the Navigation Disk and select PBX

Press the button below ENTER

Select PBX IP Address

Press the button below ENTER

Select Primary PBX

Press the button below ENTER

Enter this IP Address 192.168.2.159

Table of Contents

Do you have a question about the NS-700 and is the answer not in the manual?

Page 1 Page 1 Panasonic NS-700 Program an NT Type phone Check that DHCP is On: Power phone on When you see SETUP in the LCD, Press the button below SETUP Use the navigation disk and select Network Press the button below ENTER Look at the top of the LCD and be sure DHCP is Enable.
Page 2 Page 2 Press the button below ENTER Press the button below EXIT Press the button below EXIT Press the button below EXIT The phone will now try to log into your PBX.