Table of Contents
Advertisement
•
The upper edge of the fairing is
located into the cockpit with two
hooks. The panel must be moved
rearwards until the two hooks are
clear of the slots.
•
Disconnect the direction indicator
electrical connectors.
•
Remove the fairing.
Fairings - Installation
Installation of the fairings is the reverse
of the removal procedure, noting the
following:
•
Refit the screws securing the fairing
to the frame and tighten to 5 Nm.
•
Refit the screws securing the fairing
lower halves to each other and
tighten to 3 Nm.
•
Refit
the
screws
cockpit to the fairing and tighten to
3 Nm.
•
Refit the right hand cockpit infill
panel and tighten the screw to
3 Nm.
•
Connect the battery leads, positive
(red) lead first, see page 131.
•
Refit the battery strap.
•
Refit the rider's seat and tighten
the screws to 9 Nm, see page 67.
securing
the
General Information
Cockpit Infill Panels
The cockpit infill panels need to be
removed to gain access to the headlight
unit to replace the bulbs.
Note
Follow the same procedure for both left
and right hand sides.
Removal
To remove the cockpit infill panels:
•
Disconnect
page 129.
1
1.
Fixing
2.
Cockpit infill panel
•
Remove the fixing securing the
cockpit infill panel.
1
1.
Lift rear of panel
2.
Move the panel rearwards
the
battery,
2
see
2
69
Advertisement
Chapters
Table of Contents
