Table of Contents
Advertisement
General Information
•
Down - scroll the menu from the top
of the list to bottom
•
Left - scroll the menu to the left
•
Right - scroll the menu to the right
•
Centre - press to confirm selection.
Horn Button
When the horn button is pushed, with
the ignition switch turned on, the horn
will sound.
Right Handlebar Switches
2
3
4
5
1.
Hazard warning light switch
2.
STOP position
3.
RUN position
4.
START position
5.
Home button
Hazard Warning Lights
To turn the hazard warning lights on or
off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched off, until the
hazard warning light switch is pressed
again.
24
STOP Position
The STOP position is for emergency use.
If an emergency arises which requires
the engine to be stopped, move the
engine start/stop switch to the STOP
position.
1
1
Note
Although the engine stop switch stops
the engine, it does not turn off all the
electrical
difficulty in restarting the engine due to
a discharged battery. Ordinarily, only
the ignition switch should be used to
stop the engine.
RUN Position
In addition to the ignition switch being
turned to the ON position, the engine
start/stop switch must be in the RUN
position for the motorcycle to operate.
START Position
The START position operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar.
Note
Even if the clutch lever is pulled to the
handlebar, the starter will not operate if
the side stand is down and a gear is
engaged.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this may cause damage to
electrical
components
discharge the battery.
circuits
and
will
and
may
cause
Advertisement
Chapters
Table of Contents
