JVC LT-50VU3005 Quick Start Manual page 2

5
HDMI nput
PLEASE ENSURE BOTH UNITS ARE SWITCHED OFF
BEFORE CONNECTING. Use a HDMI to HDMI cable to
connect the two un ts together. To select the HDMI nput,
press the Source button on the remote control. Each t me t s
pressed the on-screen menu conf rms your select on.
* The appearance of the Source button may d ffer depend ng on the
model of the remote control
6
Auto Setup procedure
When turned on for the first time, the language selection screen is displayed. Select the desired
language and press OK.
On the next screen set your country preference. Then press OK to continue.
Select Home Mode for home use. You can activate Store Mode option at this point if necessary,
however, this option is only intended for store use.
Depending on the model of your TV and the country selection Privacy Settings menu may appear
at this point. Using this menu you can set your privacy privileges. Highlight a feature and use Left
and Right directional buttons to enable or disable. If the Internet Connection option is disabled
Network/Internet Settings screen will be skipped and not displayed.
H ghl ght Next and press OK button on the remote control to continue and the Network/Internet
Settings menu will be displayed.
Refer to Connect your TV to the nternet sect on to conf gure a w red or a w reless connect on.
After the sett ngs are completed h ghl ght Next and press OK button to cont nue.
Broadcast Search;
On the next screens et your preferences.
Scan Encrypted Channels
Select favourite network type
D.Aerial
D.Cable
Satellite
Analogue
When finished, highlight Next and press OK to start channel scan.
After the initial settings are completed TV will start to search for available broadcasts of the selected
broadcast types.
While the search continues a message may appear, asking whether you want to sort channels
according to the LCN(*). Select Yes and press OK to confirm.
(*) LCN is the Logical Channel Number system that organizes available broadcasts in accordance
with a recognizable channel number sequence (if available).
After the channel scan has been completed the Choose Region menu may appear. Select the
appropriate settings for your location using the directional buttons then press OK.
After all the available stations are stored, Channels menu will be displayed. You can edit the
channel list according to your preferences using the Edit tab options or press the Menu button to
quit and watch TV.
Note: Do not turn off the TV while initializing first time installation. Note that, some options may not be available
depending on the country selection.
On
Satell te
○
○
●
○
English
To HDMI connect on
SOURCE SOURCE
on the dev ce