Table of Contents
Advertisement
MI SERIES – Manual (v1.7)
Obelux Oy, Kutomotie 6 B, 00380 Helsinki FINLAND
6 CONFIGURATION
Open the two screws that secure the service access door to the chassis using a hex key. Using the DIP
switches visible and accessible via service access opening, configure the desired parameters into the light.
DIP switches are numbered 1-8, the lowest number (1) being on the leftmost edge of the red/white DIP
switch block looked from service access door. Embedded software in the obstruction light reads
configuration switches regularly. Configuration change becomes effective within few seconds.
The light can be configured between two different operating modes. Reset is needed when changing
between Stand-alone mode and Modbus mode. Configuring L864-MX-GA light is covered in chapter 6.4.
Stand-alone mode:
In this mode, the light operation is configured with DIP switches. No additional
controllers are needed.
Modbus mode:
In this mode, the light is being controlled with an additional Obelux controller.
Figure 8: Location of the DIP switches
© Obelux Oy 2017
Technical information in this document is subject to change without notice.
Page: 13(28)
Advertisement
Table of Contents
